857 research outputs found
Effects of Training Intensity on Locomotor Performance in Individuals With Chronic Spinal Cord Injury: A Randomized Crossover Study
Background. Many physical interventions can improve locomotor function in individuals with motor incomplete spinal cord injury (iSCI), although the training parameters that maximize recovery are not clear. Previous studies in individuals with other neurologic injuries suggest the intensity of locomotor training (LT) may positively influence walking outcomes. However, the effects of intensity during training of individuals with iSCI have not been tested. Objective. The purpose of this pilot, blinded-assessor randomized trial was to evaluate the effects of LT intensity on walking outcomes in individuals with iSCI. Methods. Using a crossover design, ambulatory participants with iSCI \u3e1 year duration performed either high- or low-intensity LT for ≤20 sessions over 4 to 6 weeks. Four weeks following completion, the training interventions were alternated. Targeted intensities focused on achieving specific ranges of heart rate (HR) or ratings of perceived exertion (RPE), with intensity manipulated by increasing speeds or applying loads. Results. Significantly greater increases in peak treadmill speeds (0.18 vs 0.02 m/s) and secondary measures of metabolic function and overground speed were observed following high- versus low-intensity training, with no effects of intervention order. Moderate to high correlations were observed between differences in walking speed or distances and differences in HRs or RPEs during high- versus low-intensity training. Conclusion. This pilot study provides the first evidence that the intensity of stepping practice may be an important determinant of LT outcomes in individuals with iSCI. Whether such training is feasible in larger patient populations and contributes to improved locomotor outcomes deserves further consideration
Faint High Latitude Carbon Stars Discovered by the Sloan Digital Sky Survey: Methods and Initial Results
We report the discovery of 39 Faint High Latitude Carbon Stars (FHLCs) from
Sloan Digital Sky Survey commissioning data. The objects, each selected
photometrically and verified spectroscopically, range over 16.6 < r* < 20.0,
and show a diversity of temperatures as judged by both colors and NaD line
strengths. At the completion of the Sloan Survey, there will be many hundred
homogeneously selected and observed FHLCs in this sample. We present proper
motion measures for each object, indicating that the sample is a mixture of
extremely distant (>100 kpc) halo giant stars, useful for constraining halo
dynamics, plus members of the recently-recognized exotic class of very nearby
dwarf carbon (dC) stars. Motions, and thus dC classification, are inferred for
40-50 percent of the sample, depending on the level of statistical significance
invoked. The new list of dC stars presented here, although selected from only a
small fraction of the final SDSS, doubles the number of such objects found by
all previous methods. (Abstract abridged).Comment: Accepted for publication in The Astronomical Journal, Vol. 124, Sep.
2002, 40 pages, 7 figures, AASTeX v5.
The Sloan Digital Sky Survey Quasar Catalog I. Early Data Release
We present the first edition of the Sloan Digital Sky Survey (SDSS) Quasar
Catalog. The catalog consists of the 3814 objects (3000 discovered by the SDSS)
in the initial SDSS public data release that have at least one emission line
with a full width at half maximum larger than 1000 km/s, luminosities brighter
than M_i^* = -23, and highly reliable redshifts. The area covered by the
catalog is 494 square degrees; the majority of the objects were found in SDSS
commissioning data using a multicolor selection technique. The quasar redshifts
range from 0.15 to 5.03. For each object the catalog presents positions
accurate to better than 0.2" rms per coordinate, five band (ugriz) CCD-based
photometry with typical accuracy of 0.05 mag, radio and X-ray emission
properties, and information on the morphology and selection method. Calibrated
spectra of all objects in the catalog, covering the wavelength region 3800 to
9200 Angstroms at a spectral resolution of 1800-2100, are also available. Since
the quasars were selected during the commissioning period, a time when the
quasar selection algorithm was undergoing frequent revisions, the sample is not
homogeneous and is not intended for statistical analysis.Comment: 27 pages, 4 figures, 4 tables, accepted by A
High-Redshift Quasars Found in Sloan Digital Sky Survey Commissioning Data II: The Spring Equatorial Stripe
This is the second paper in a series aimed at finding high-redshift quasars
from five-color (u'g'r'i'z') imaging data taken along the Celestial Equator by
the Sloan Digital Sky Survey (SDSS) during its commissioning phase. In this
paper, we present 22 high-redshift quasars (z>3.6) discovered from ~250 deg^2
of data in the spring Equatorial Stripe, plus photometry for two previously
known high-redshift quasars in the same region of sky. Our success rate of
identifying high-redshift quasars is 68%. Five of the newly discovered quasars
have redshifts higher than 4.6 (z=4.62, 4.69, 4.70, 4.92 and 5.03). All the
quasars have i* < 20.2 with absolute magnitude -28.8 < M_B < -26.1 (h=0.5,
q_0=0.5). Several of the quasars show unusual emission and absorption features
in their spectra, including an object at z=4.62 without detectable emission
lines, and a Broad Absorption Line (BAL) quasar at z=4.92.Comment: 28 pages, AJ in press (Jan 2000), final version with minor changes;
high resolution finding charts available at
http://www.astro.princeton.edu/~fan/paper/qso2.htm
An Initial Survey of White Dwarfs in the Sloan Digital Sky Survey
An initial assessment is made of white dwarf and hot subdwarf stars observed
in the Sloan Digital Sky Survey. In a small area of sky (190 square degrees),
observed much like the full survey will be, 269 white dwarfs and 56 hot
subdwarfs are identified spectroscopically where only 44 white dwarfs and 5 hot
subdwarfs were known previously. Most are ordinary DA (hydrogen atmosphere) and
DB (helium) types. In addition, in the full survey to date, a number of WDs
have been found with uncommon spectral types. Among these are blue DQ stars
displaying lines of atomic carbon; red DQ stars showing molecular bands of C_2
with a wide variety of strengths; DZ stars where Ca and occasionally Mg, Na,
and/or Fe lines are detected; and magnetic WDs with a wide range of magnetic
field strengths in DA, DB, DQ, and (probably) DZ spectral types. Photometry
alone allows identification of stars hotter than 12000 K, and the density of
these stars for 15<g<20 is found to be ~2.2 deg^{-2} at Galactic latitudes
29-62 deg. Spectra are obtained for roughly half of these hot stars. The
spectra show that, for 15<g<17, 40% of hot stars are WDs and the fraction of
WDs rises to ~90% at g=20. The remainder are hot sdB and sdO stars.Comment: Accepted for AJ; 43 pages, including 12 figures and 5 table
Galaxy Clustering in Early SDSS Redshift Data
We present the first measurements of clustering in the Sloan Digital Sky
Survey (SDSS) galaxy redshift survey. Our sample consists of 29,300 galaxies
with redshifts 5,700 km/s < cz < 39,000 km/s, distributed in several long but
narrow (2.5-5 degree) segments, covering 690 square degrees. For the full,
flux-limited sample, the redshift-space correlation length is approximately 8
Mpc/h. The two-dimensional correlation function \xi(r_p,\pi) shows clear
signatures of both the small-scale, ``fingers-of-God'' distortion caused by
velocity dispersions in collapsed objects and the large-scale compression
caused by coherent flows, though the latter cannot be measured with high
precision in the present sample. The inferred real-space correlation function
is well described by a power law, \xi(r)=(r/6.1+/-0.2 Mpc/h)^{-1.75+/-0.03},
for 0.1 Mpc/h < r < 16 Mpc/h. The galaxy pairwise velocity dispersion is
\sigma_{12} ~ 600+/-100 km/s for projected separations 0.15 Mpc/h < r_p < 5
Mpc/h. When we divide the sample by color, the red galaxies exhibit a stronger
and steeper real-space correlation function and a higher pairwise velocity
dispersion than do the blue galaxies. The relative behavior of subsamples
defined by high/low profile concentration or high/low surface brightness is
qualitatively similar to that of the red/blue subsamples. Our most striking
result is a clear measurement of scale-independent luminosity bias at r < 10
Mpc/h: subsamples with absolute magnitude ranges centered on M_*-1.5, M_*, and
M_*+1.5 have real-space correlation functions that are parallel power laws of
slope ~ -1.8 with correlation lengths of approximately 7.4 Mpc/h, 6.3 Mpc/h,
and 4.7 Mpc/h, respectively.Comment: 51 pages, 18 figures. Replaced to match accepted ApJ versio
Upper limits on the strength of periodic gravitational waves from PSR J1939+2134
The first science run of the LIGO and GEO gravitational wave detectors
presented the opportunity to test methods of searching for gravitational waves
from known pulsars. Here we present new direct upper limits on the strength of
waves from the pulsar PSR J1939+2134 using two independent analysis methods,
one in the frequency domain using frequentist statistics and one in the time
domain using Bayesian inference. Both methods show that the strain amplitude at
Earth from this pulsar is less than a few times .Comment: 7 pages, 1 figure, to appear in the Proceedings of the 5th Edoardo
Amaldi Conference on Gravitational Waves, Tirrenia, Pisa, Italy, 6-11 July
200
Improving the sensitivity to gravitational-wave sources by modifying the input-output optics of advanced interferometers
We study frequency dependent (FD) input-output schemes for signal-recycling
interferometers, the baseline design of Advanced LIGO and the current
configuration of GEO 600. Complementary to a recent proposal by Harms et al. to
use FD input squeezing and ordinary homodyne detection, we explore a scheme
which uses ordinary squeezed vacuum, but FD readout. Both schemes, which are
sub-optimal among all possible input-output schemes, provide a global noise
suppression by the power squeeze factor, while being realizable by using
detuned Fabry-Perot cavities as input/output filters. At high frequencies, the
two schemes are shown to be equivalent, while at low frequencies our scheme
gives better performance than that of Harms et al., and is nearly fully
optimal. We then study the sensitivity improvement achievable by these schemes
in Advanced LIGO era (with 30-m filter cavities and current estimates of
filter-mirror losses and thermal noise), for neutron star binary inspirals, and
for narrowband GW sources such as low-mass X-ray binaries and known radio
pulsars. Optical losses are shown to be a major obstacle for the actual
implementation of these techniques in Advanced LIGO. On time scales of
third-generation interferometers, like EURO/LIGO-III (~2012), with
kilometer-scale filter cavities, a signal-recycling interferometer with the FD
readout scheme explored in this paper can have performances comparable to
existing proposals. [abridged]Comment: Figs. 9 and 12 corrected; Appendix added for narrowband data analysi
Measurement of Rapidity Distribution for High Mass Drell-Yan ee Pairs at CDF
We report on the first measurement of the rapidity distribution dsigma/dy
over nearly the entire kinematic region of rapidity for e^+e^- pairs in the
Z-boson region of 66116 GeV/c^2.
The data sample consists of 108 pb^{-1} of ppbar collisions at \sqrt{s}=1.8 TeV
taken by the Collider Detector at Fermilab during 1992--1995. The total cross
section in the -boson region is measured to be 252 +- 11 pb. The measured
total cross section and d\sigma/dy are compared with quantum chromodynamics
calculations in leading and higher orders.Comment: 7 pages, 3 figures. Submitted to Physical Review Letter
Measurement of the p\bar{p}\sqrt{s}$ = 1.8 TeV
We update the measurement of the top production cross section using the CDF
detector at the Fermilab Tevatron. This measurement uses decays to
the final states +jets and +jets. We search for quarks from
decays via secondary-vertex identification or the identification of
semileptonic decays of the and cascade quarks. The background to the
production is determined primarily through a Monte Carlo simulation.
However, we calibrate the simulation and evaluate its uncertainty using several
independent data samples. For a top mass of 175 , we measure
pb and pb using
the secondary vertex and the lepton tagging algorithms, respectively. Finally,
we combine these results with those from other decay channels and
obtain pb.Comment: The manuscript consists of 130 pages, 35 figures and 42 tables in
RevTex. The manuscript is submitted to Physical Review D. Fixed typo in
author lis
- …